Sony XAV-AX210 Service Manual page 6

XAV-AX210
3. Connect the power cord to the regulated DC power supply, and
turn the power on this unit.
Note 4: It is not necessary to install the top cover and mechanism deck that
were removed in step 1.
mechanism deck
4. Press the [OFF] button on the remote commander to the state
of source off, enter the destination setting mode by pressing the
buttons on the remote commander in order of the [4] t [5] t
[6] (press only the [6] button for two seconds).
(Displayed screen in the above fi gure are example)
5. The following screen is displayed and the destination setting
mode becomes effective.
<DESTINATION SETTING MODE>
0 0
UC:*00001
(Displayed characters/values in the above fi gure are example)
6
top cover
Regulated DC
power supply
+
–
0 0 0 7
FT(JPN):*00007
6. Input the 6 digits destination code (000001).
Press the [V] or [v] button on the remote commander to select
"0" with the 6th digit and press the [b] button on the remote
commander.
Press the [V] or [v] button on the remote commander to select
"0" with the 5th digit and press the [b] button on the remote
commander.
Press the [V] or [v] button on the remote commander to select
"0" with the 4th digit and press the [b] button on the remote
commander.
Press the [V] or [v] button on the remote commander to select
"0" with the 3rd digit and press the [b] button on the remote
commander.
Press the [V] or [v] button on the remote commander to select
"0" with the 2nd digit and press the [b] button on the remote
commander.
Press the [V] or [v] button on the remote commander to select
"1" with the 1st digit and press the [ENTER] button on the re-
mote commander, then the unit reboots and returns to the normal
condition.
Note 5: The digit return by pressing the [B] button on the remote command-
er.
Note 6: The destination code cannot be inputted by operation of main unit.
Be sure to input the destination code by using the remote commander.
[V] press to select
the alphanumeric
characters.
[B] press to return
the digit.
[v] press to select
the alphanumeric
characters.
<DESTINATION SETTING MODE>
0 0 0 0 0 1
UC:*00001 FT(JPN):*00007
7. Refer to step 2 and after in "DESTINATION CHECKING
METHOD" on page 5, and confi rm a correct destination was set.
8. Disconnect the power cord from the regulated DC power supply,
and turn the power off this unit.
Sony CONFIDENTIAL
For Authorized Servicer
[b] press to
advance the digit.
Press [ENTER] by the
1st digit to complete
the setting.
0 0 0 0 0 1
6th 5th 4th 3rd 2nd 1st
6 digits
Regulated DC
power supply
+
–
– Continued on next page –
SYS SET