Transportation And Storage; Technical Data - Husqvarna 122C Operator's Manual

Check
Spark plug.
The engine starts but stops again
Check
Fuel tank
Air filter
• Always allow the product to cool down before
storage.
• For storage and transportation of the product and
fuel, make sure that there are no leaks or fumes.
Sparks or open flames, for example from electrical
devices or boilers, can start a fire.
• Always use approved containers for storage and
transportation of fuel.
• Empty the fuel before transportation or before long-
term storage. Discard the fuel at an applicable
disposal location.

Technical data

Engine
Cylinder displacement, cm
Idle speed, rpm
Recommended max. speed, rpm
Speed of output shaft, rpm
Power / Max. engine output, acc. to ISO 8893, kW/hp @ rpm
941 - 005 - 22.09.2020
Possible cause
The spark plug is dirty or wet.
The spark plug electrode gap is incorrect.
The spark plug is loose.
Possible cause
Incorrect fuel type.
The air filter is clogged.

Transportation and storage

Technical data
3
Procedure
Make sure that the spark plug is dry and
clean.
Clean the spark plug. Make sure that the
electrode gap is correct. Make sure that the
spark plug has a supressor.
Technical data on page 17 for cor-
Refer to
rect electrode gap.
Tighten the spark plug.
Procedure
Empty the fuel tank and fill it with correct fuel.
Clean the air filter.
• Attach the transport guard during transportation and
storage.
• Remove the spark plug cap from the spark plug.
• Attach the product during transportation. Make sure
that it cannot move.
• Clean and do servicing on the product before long-
term storage.
122C
21.7
2900
7200
7200
0.6/0.8 @ 7800
122LK
21.7
2900
9100
6232
0.6/0.8 @ 7800
17