Projector And Accessories; Front/Upper Side And Accessories - Samsung SP-H700AE Owner's Instructions Manual

PROJECTOR AND ACCESSORIES

Front/Upper Side and Accessories

Front/Upper Side
1
2
Indicators
1 1
- TEMP (Red LED)
- LAMP (Blue LED)
- STAND BY (Blue LED)
Refer to page 13 for details.
Remote Control Signal Receiver
2 2
3 3 Focus Ring
Used for Focus Adjustment.
4 4 Lens
5 5 Adjustable Feet
You can adjust the screen position by moving
up and down the adjustable feet.
Zoom Knob
6 6
Used to enlarge or reduce image size.
Accessories
Remote Control(BP59-00036A)/
2 Batteries
12
11
10
9
8
7
6
3
4
5
MENU
7 7
Used to open the on-screen Menu.
POWER
8 8
Used to turn the projector on or off.
9 9 SOURCE
Used to select input signals from the external
sources.
1 1 0 0 Select and Move Button
Used to select an menu item, and to move the
cursor.
LENS SHIFT Dial
1 1 1 1
You can adjust screen images up and down
within the lens range.
Power Cable Owner's Instructions
(3903-000085) (including a warranty certificate)
Indicator Information
: Turned On : Flashing : Turned Off
TEMP LAMP STANDBY
If you press the POWER button on the remote control or projector, the screen
appears within 30 seconds.
The projector is in normal operating condition.
The projector is warming up after POWER button has been pressed.
The POWER button is pressed to turn off the projector, and the cooling system is
in operation to cool off inside of the projector. (Lasts for about 1 minute and 30
seconds)
Refer to measure 1 below if the cooling fan inside the projector is not in normal
operation condition.
Refer to measure 2 below if the lamp cover protecting the lamp unit is not closed
properly.
Power is turned off automatically when temperature inside of the projector goes
beyond the control limit. Refer to measure 3.
Refer to measure 4 below if the life span of the lamp is running out or a problem
with the lamp is detected.
Clearing Indicator Problems
Classification State
Measure 1 When the cooling fan system is Unplug and plug the cord and restart the projector. If the
not in normal operating condition. problem does not disappear, contact a dealer or service
personnel near you.
Measure 2
When the lamp cover protecting Check the screw on the bottom side of the projector. If you
the lamp unit is not properly do not find any problem, contact a dealer or service
closed or the sensor system is not personnel near you.
in normal operating condition.
When temperature inside of the Adjust the position of the projector following the
Measure 3
projector becomes too high. installation instructions of this manual and cool off the
projector before restarting it. If the problem does not
disappear, contact a dealer or service personnel near you.
Measure 4 The lamp is malfunctioning after Power off the projector and cool it off for some time before
abnormal power off or restarting restarting it.
right after turning off the projector.
When brightness of the picture Check how long the lamp has been used on Information
screen degrades or image and contact a dealer or service personnel near you for lamp
deterioration is found. replacement.
This Projector uses a cooling fan system to keep the unit from overheating.
Operation of the cooling fan may cause noise, which does not affect the product performance.
NOTE
No exchange or refund for the noise concern.
Information
Measures
13