Networks And The Internet - Samsung HT-EM35 User Manual

Networks and the Internet

When you connect this product to a network, you
can use network based applications and functions
such as BD-LIVE and upgrade the product's
software through the network connection.
Configuring Your Network Connection
Before you begin, contact your ISP to find out
if your IP address is static or dynamic. If it is
dynamic, we recommend you use the Automatic
procedure below. If it is static, you must use the
Manual procedure that follows.
• Before you begin, confirm that the product is
connected to your router with a network cable.
K
Automatic
To start the configuration process, follow these
steps:
1 . In the Home menu, select Settings, and then
press the E button.
2 . Select Network, and then press the E
button.
3 . Select Wired Network Settings, and then
press the E button.
The Wired Network Settings screen appears.
►
4 . Press the
Setup menu.
▲▼
Use button to select Auto, and then
press the E button.
Settings
Display
Internet Protocol Setup : Auto
Audio
IP Address
Network
Subnet Mask
System
Gateway
Language
Security
DNS
General
DNS Server
Support
5 . The Network function acquires and fills in the
values for IP Address, Subnet Mask, etc.,
automatically.
HT-EM35_ZA_0227.indd 25 HT-EM35_ZA_0227.indd 25
button on the Internet Protocol
Wired Network Settings
\
: 0 0 0 0
: 0 0 0 0
: 0 0 0 0
: Auto
: 0 0 0 0
'
> Move " Select
Return
6 . After the Network function has acquired
the network values, press the RETURN ( ' )
button.
7 . Select Network Test, and then press E .
The home theater validates the network
connection. When it is done, press the
RETURN ( ' ) button.
K
Manual
If you have a static IP address or the Automatic
procedure does not work, you'll need to set the
Network Settings values manually.
Settings
Wired Network Settings
Display
Internet Protocol Setup : Manual
Audio
IP Address : 0
Network
Subnet Mask : 255 255 255
System
Gateway : 0
Language
Security
DNS : Manual
General
DNS Server : 0
Support
> Move " Select
1 . Follow the first four steps in the Automatic
procedure, but select Manual instead of Auto
in Step 4.
▼
2 . Press the button to go to the first entry
field (IP Address).
3 . Use the number buttons on your remote to
enter numbers.
4 . When done with each field, use the ► button
to move successively to the next field.
You can also use the other arrow buttons to
move up, down, and back.
5 . Enter the IP Address, Subnet Mask, and
Gateway values.
6 . Press the ▼ button to go to DNS.
7 . Press the ▼ button to go to the first DNS
entry field. Enter the numbers as above.
8 . Press the RETURN ( ' ) button on your
remote.
\
0 0 0
0
0 0 0
0 0 0
'
Return
25
|
English
2012-02-27 오전 10:54:27 2012-02-27 오전 10:54:27