Dimplex XLF50 Owner's Manual page 16

Operation
the fan decreasing to reduce
the amount of heat being
projected into the room.**
E. Temperature Up
Increases the temperature
setting.
Adjusted by repeatedly
pressing the corresponding
button on the remote.*
• Indicated by the setpoint on
the Display increasing and the
speed of the fan increasing to
increase the amount of heat
being projected into the room.
* The first time the button
is pressed the current
temperature set point will be
displayed for 2 seconds.
** The temperature can be
adjusted from 5 °C to 37 °C
(41 °F to 99 °F).
! NOTE: Holding the
the buttons down for two
seconds, on the unit, will change
the temperature scale from
°C to °F, or vice versa.
F. Eco Operation
Runs the heater in a reduced
wattage range when activated.
Adjusted by pressing the
corresponding button on the
16
remote when the heater is on.
• Indicated by the Display and a
reduced fan speed.
G.
Turns the Heater Boost On and
Off. Runs the unit at the full rated
wattage.
Activated and adjusted by
repeatedly pressing the
corresponding button on
the remote.
• Indicated by the heater running
at full heat, for a user set
amount of time, to quickly heat
up a cold room/space. The
Heat Boost can be set for a
maximum of 20 minutes, in
5 minute increments.
Disable Heat
If desired, depending on the
season, the heater on the unit can
be disabled. The function of the
and
remaining controls will continue
to function as outlined in this
manual.
Pressing the
on the unit at the same time and
holding for 2 seconds will disable
and enable the heater.
! NOTE: When the heater has
been disabled and any of the heat
Heat Boost
and
www.dimplex.com
buttons