Haier HWD100-BP14636 User Manual page 25

EN
Problem Cause
• Temperature sensor-error
F3
• Heating-error
F4
• Motor-error
F7
F9 • Dry temperature sensor-error
FA • Water level sensor-error
FC1 or • Abnormal communication-error
FC2
• Dry heating element-error
Fd
• Dry motor-error
FE
UNB • Unbalanced load-error
9.3 Troubleshooting without display code
Problem
Appliance fails to
operate.
Appliance will not be
filled with water.
Appliance is draining
while being filled
Drainage failure
Cause
• Programme is not yet started.
• Door is not properly closed.
• Machine has not been switched on
• Power failure.
• Child lock is activated
• No water.
• Inlet hose is kinked.
• Inlet hose filter is blocked.
• Water pressure is less than 0.03
MPa.
• Door is not properly closed.
• Water supply failure.
• Height of drain hose is below 80
cm.
• Drain hose end could reach into water.
• Drain hose is blocked.
• Pump filter is blocked.
• Drain hose end is higher than 100
cm above floor level.
9- Troubleshooting
Solution
• Contact the After sales service.
• Contact the After sales service.
• Contact the After sales service.
• Contact the After sales service.
• Contact the After sales service.
• Contact the After sales service.
• Contact the After sales service.
• Contact the After sales service.
• Check and balance laundry load in the drum.
Reduce the load.
Solution
• Check programme and start it.
• Close the door properly.
• Switch the machine on.
• Check power supply.
• Deactivate child lock.
• Check water tap.
• Check inlet hose.
• Unblock inlet hose filter.
• Check water pressure.
• Close the door properly.
• Ensure the water supply
• Make sure that drain hose is
properly installed.
• Make sure the drain hose is not
in water.
• Unblock drain hose.
• Clean pump filter.
• Make sure that drain hose is
properly installed.
25