Haier HWD100-BP14636 User Manual page 19

EN
6.10 Start wash programme
Press "Start/Pause" button (Fig. 6-10) to start. Appli-
ance operates according to present settings. Changes
are only possible by cancelling the programme.
Note: Door lock
▶ For safety reasons the door is locked partially during the washing /drying cycle. It is
only possible to open the door at the end of the programme or after the programme
was cancelled correctly (see description above).
▶ In case of high water level, high water temperature and during spinning it is not pos-
sible to open the door; Loc
6.11 Interrupt - cancel wash programme
To interrupt a running programme press gently "Start/Pause". The LED above the button
is flashing. Press it again to resume operation.
To cancel a running programme and all its individual settings
1. Press "Start/Pause" button to interrupt the running programme.
2. Press „On/Off" button for about 2 seconds to switch the appliance off.
3. Run programme SPIN and select "no Speed" (all lights are off ) to drain the water.
4. Select a new programme and start it.
6.12 After washing
1. At programme cycle end END is displayed.
2. The appliance switches off automatically.
3. Remove laundry as soon as possible to go easy on it and to prevent more wrinkling.
4. Turn off the water supply.
5. Unplug the power cord.
6. Open the door to prevent formation of moisture and odours. Let it open while not used.
Note: Cool down cycle for drying cycle
The last part of the drying cycle occurs without heat to ensure remaining the garments
at a temperature which does not damage them.
Note: Standby mode / energy-saving mode
The switched on appliance will go into standby mode if Pause-button is pressed. This
saves energy. The display switsches off. To interrupt the standby mode push "Start/
Pause" button.
is displayed.
1-
6- Daily use
Start/Pause
6-10
19