Table of Contents
Advertisement
Speed
The Speed menu enables you to show the response time on any
individual channel (such as retracts).
The Speed is adjustable in the following ranges:
• Nor (No Delay)–0.9s in 0.1 second increments
• 1s–2s in 0.2-second increments
• 2s–8s in 1-second increments
To adjust the Speed
1. Scroll to the channel you wish to adjust and press
the scroll wheel.
2. Scroll left or right to adjust the speed and press the
scroll wheel to save the selection.
D/R & Exponential
Differential (Air and Sail Types only)
The Differential screen enables you to increase or decrease the
amount of differential between aileron control surface throws.
Positive Differential values decrease the amount of "down" travel
without affecting the "up" travel on the opposite control surface.
Negative Differential values decrease the amount of "up" travel
without affecting the amount of "down" travel on the opposite
control surface.
SPEKTRUM DX18t • TRANSMITTER INSTRUCTION MANUAL
Absolute (Abs.) Travel
The Abs. Travel function limits the amount of travel on a channel.
Adjust the Abs. Travel value to prevent a servo from binding when
a mix is applied.
Balance
Balance is available on all channels to fine-tune the servo position
at up to 7 points. This is a precision curve mix that is normally
used to prevent binding when multiple servos are used on
a single control surface.
You can also use the Balance menu option to match throttle
response on twin engine aircraft or level the swashplate
on a helicopter.
Dual Rates and Exponential are available on the aileron, elevator and rudder channels.
To adjust the Dual Rate and Exponential:
1. Scroll to the channel and press the scroll wheel once. Scroll left or right to select the
channel you wish to change and press the scroll wheel again to save the selection.
2. Scroll to dual rate and press the scroll wheel. Scroll left or right to change the value
and press the scroll wheel again to save the selection.
Exponential affects control response sensitivity around center but has no affect on overall
travel. Positive exponential decreases the sensitivity around the center of gimbal movement.
The Differential menu option only appears when a multi-servo
aileron wing type is active in Aircraft Type.
To adjust the Differential:
1. Scroll to Switch and press the scroll wheel. Scroll right to
2. Press the scroll wheel a second time to save the selection.
3. Scroll to the percentage selection and press the scroll wheel
4. Press the scroll wheel again to save the selection.
select On (Differential is always on) or assign the differential to
a switch position.
once to change the value.
EN
25
Advertisement
Table of Contents
