Table of Contents
Advertisement
Supplying Power
Charge the Battery Pack
Charge the Battery Pack fully
before operation.
POWER
Lamp n
CHARGE
Lamp
Plug in the AC Adaptor.
POWER Lamp lights up.
f
Insert the Battery
® Align the right side of the Battery
with the line on the AC Adaptor.
<D Press down on the Battery and then
slide it in the direction of the arrow.
CHARGE Lamp lights up. It goes out
when charging is done (about one and
^a half hours).
i Remove the Battery
Slide the Battery out and then lift up.
After recharging the Battery Pack about 5 times,
use the BATTERY REFRESH feature as
explained on page 9.
Use the Battery Pack
The useful operation time of the Battery will
gradually decrease after repeated use and
recharging. The Battery is no longer
serviceable if the operation time is very short,
even after a sufficient charge.
With a fully charged Battery Pack, you will have a maximum of about one and a half
hours of continuous use (LCD monitor is off) or about one hour of continuous use (LCD
monitor is on). (If the Built-in Light is used, battery operating time decreases.)
. Attach the Battery
® Align the Battery with the top of the
mounting surface.
® Press it into place until it locks with a
click.
8
Remove the Battery
While sliding the BATTERY RELEASE
button, remove the Battery.
Advertisement
Table of Contents
