Samsung HP-S4253 Owner's Instructions Manual page 12

˛ P.MODE button
Adjust the TV picture by selecting one of the preset factory settings (or
select your personal, customized picture settings). (Refer to page 53)
◊ S.MODE button
Select Sound effect. (Refer to page 67)
± MTS button
Press to choose stereo, mono or Separate Audio Program
(SAP broadcast).
≠ SRS button
Activates TruSurround. (Refer to page 68)
– AUTO PROG. button
Press to display the memorized channels menu. (Refer to page 37)
— ADD/DEL button
Press to add or erase channels in the TV's memory. (Refer to page 81)
÷ STILL button
Press to pause the current screen.
® P.SIZE button
Select Picture size. (Refer to page 56)
∑ PIP control buttons
SWAP: Interchange the main and sub picture.
CH , : Displays the available channels in sequence.
(These buttons change channels in the PIP window only.)
µ CAPTION button
Controls the caption decoder.
¥ RESET button
If your remote control is not functioning properly, take out the batteries
and press the reset button for about 2~3 seconds.
Re-insert the batteries and try using the remote control again.
≥ SET button
Used during set up of this Samsung remote control, so that it will work
compatibly with other devices (VCR, Cable Box and DVD).
Note
• This is a special remote control for the visually impaired, and has Braille points on the Power,
Channel and Volume buttons.
1
Lift the cover at the back of
the remote control upward
as shown in the figure.
Remote Control Operation Range
You can use your remote control within a distance of 23 feet and an angle of 30 degrees
12
from the left and right sides of the TV's remote control receiver.
Installing the Batteries in Your Remote Control
2
Install two AAA size batteries.
Make sure to match the "+" and
"-" ends of the batteries with the
diagram inside the compartment.
•
Do not mix battery types, i.e.
alkaline and manganese.
3
Close the cover as shown
in the figure.