Assembly With Outward Opening Window - Master CLOUD SYNCRO 230V Instruction Manual

Check that once the actuator has been installed the
distance between the fixed part of the window frame
(where the actuator is to be assembled) and the
mobile part of the window frame (where the bracket is
to be fixed) is greater than or equal to 0 mm (Fig. 1). If
this is not the case the actuator will not function
correctly as the window will not close correctly. If
required, add additional thickness below the support
brackets to reset the quota.
For bottom hung window frames injury could be caused by accidental falls of
the window. An appropriately sized flexible link arm or fall prevention safety
system designed to resist a force equal to at least three times the total weight
of the window MUST be installed.

8.1. Assembly with outward opening window.

Aside the drawing of specific application using
accessories provided.
please contact manufacturer.
A. Divide the frame in 3 parts and trace two "X".
B. Select the correct form of brackets (Fig. 2).
C. Attach the template to the window frame (fixed part)
and line axis up with the 2 "X" traced earlier (Fig. 3).
Warning: for window frames not on the same plane,
cut the part of the template coloured in grey and fix
this to the moveable part of the window frame, taking
care to keep it in the same position.
D. Bore holes in the window frame at the points indicated
on the template (Fig. 4).
E. Assemble the two brackets with the distancer (to help
position correctly. Once it has served its purpose it can
be removed). Mount the supports onto the frame with
the appropriate
everything is aligned both horizontally and vertically.
F. Mount the bracket for outward opening windows onto
the moveable part of the frame in accordance with the
markings indicated on the template.
G. Complete assembly of the chain terminal with the
rapid release hook inserted onto the pin Ø4x32
(provided) in median position (Fig. 5).
H. Mount the actuator onto the brackets by inserting the
two openings at each side onto the corresponding pins
on the brackets.
I. Rotate the actuator 90°, bring the chain terminal up to
the bracket and insert the pin into the opening on the
bracket. Insert the rapid release hook into the bracket.
For the first few times, this may fairly stiff, but in time the
pieces involved will adapt to their positions.
For different
screws provided.
Page 8
mountings,
Check that
Figure 1
Outward application
Figure 2
Figure 3
Figure 4