Setting For Synchronized Operation (Chain Alignment And Address Acquisition) - Master CLOUD SYNCRO 230V Instruction Manual

• Isolate the actuators from the power source.
• Remove the chains from the attachment of the window.
• Position the dip-switches of the machine as shown in the table below.
• Power the machine in any direction: the machine automatically moves the chain in
the closing and then opening direction, stopping automatically in the end position
(about 8 cm).
• Cut off power to the machine.
• Position dip-switches No.1 and No.2 according to the desired stroke (see the
opening stroke-end table).
• Connect the machine to the power supply again and carry out some opening and
closing manoeuvres.
10.4. Setting for synchronized operation (chain alignment and address
acquisition)
IMPORTANT. This procedure should be carried out for all the
actuators that you want to synchronize with one another.
NOTE. In the case of just 2 actuators, they are already factory-set; if
there are more than 2 or in the event of replacements, follow the
instructions below.
• Ensure that all the connections of the wires, including the synchronization wires,
have been made correctly.
• Isolate the actuators from the power source.
• Remove the chains from the attachment of the window.
• Position the dip-switches of the machines as shown in the table below.
• Power the machines in any direction: the machines automatically move the chain in
the closing and then opening direction, stopping automatically in the end position
(about 8 cm).
• Ensure that all the machines have the chains aligned at the same position (about 8
cm). If the chains are not at the same position, repeat the procedure from the
beginning.
• Cut off power to the machines.
• Position the dip-switches according to the table below for acquisition of the
addresses.
Dip-switch
No. 1 No. 2
OFF OFF
Dip-switch
No. 1 No. 2
OFF OFF
Dip-switch
No. 1 No. 2
OFF OFF
Page 12
No. 3 No. 4
ON OFF
No. 3 No. 4
ON OFF
No. 3 No. 4
OFF OFF