Table of Contents
Advertisement
1. Release the rapid release hook locking the chain terminal
to the bracket.
2. Hold the window with one hand and pull the pin out of the
opening with the other hand.
3. Manually open the window frame.
A
TTENTION
sash is no longer held in position by the chain.
4. After maintenance and/or cleaning repeat points 1 and 2 in reverse order.
13. Troubleshooting
Please consult the following table for any eventual problems with function during
installation or normal use:
Problem
Actuator doesn't
work
Although selection
has been carried
out correctly the
gearmotor will not
take a limit switch.
14. Environmental protection
All materials used in the manufacture of this appliance are recyclable. We recommend that the
device itself, and any accessories, packaging, etc. be sent to a centre for ecological recycling.
15. Warranty
The Manufacturer guarantees good machine function and undertakes to replace any defective
parts due to bad quality materials or construction defects in accordance with article 1490 of the
Civil Code. This warranty covers products for a period of 2 years from the date of purchase.
The warranty is valid if the buyer can present proof of purchase and has satisfied any conditions
of payment accorded. The guarantee of good function of the device accorded by the
manufacturer is understood to cover the replacement of any eventual parts that should be
damaged when under warranty. The Buyer has no right to any compensation for possible
damages, direct or indirect, or other expenses. Any attempt at repair by unauthorised persons
renders this warranty null and void. All fragile parts and those parts exposed to natural wear, as
well as parts submitted to agents or corrosive processes, temporary overload etc. are excluded
from this warranty. The Manufacturer will not accept responsibility for possible damages caused
by erroneous assembly, movement or insertion, use of excessive stress or improper use. Any
repairs carried out under warranty are always intended "Ex-factory producer". Relative transport
expenses (outgoing / return) will be the responsibility of the Buyer.
:
– the window could fall as the
DANGER
Possible cause
• No electricity supply for
feeder.
• Connecting cable not
connected or wire not
connected.
• Feeder doesn't deliver
foreseen tension (24V).
• Programming hasn't been
carried out correctly.
• Irregular function or break in
the electrical contact for the
dip-switch.
Page 14
Solution
• Check state of safety
switch.
• Check all electrical
connections of gear motor.
• Possible transformer
winding break down.
• Repeat programming for
dipswitch.
• Send gear motor to a
Service Centre.
Hide quick links:
Advertisement
Table of Contents
