Maintenance
Step
(9) Warm up the engine
Engine oil pan
Engine oil pan
filter port
filter port
2
Replacing the oil filter
Part name Oil filter
Tools/materials Oil filter wrench, waste cloth, torque wrench
Step
(1) See "Basics" (page 213)
(2) Remove the oil filter
(3) Install the oil filter
(4) Clean
215
1. Run the engine for approximately 3 minutes.
2. Stop the engine and wait for a few minutes. Then check the oil level.
Use an oil filter wrench.
• Do not use a filter wrench when tightening the filter (this does not apply
to a torque wrench).
1. Clean the engine mounting portion.
2. Apply engine oil to the O-ring mating surface.
3. Tighten the oil filter.
Tightening torque: 20 to 24 N·m (Use a torque wrench.)
If no torque wrench is available, tighten the filter by hand, rather than
using a filter wrench. A filter wrench tends to result in overtightening,
which may cause such problems as breakage and oil leaks.
Wipe off spilt oil.
Task
Oil level gauge reference
Indication
Task
Oil filter
Oil filter
006315-00E
SiAUY361411EA
Remarks
Check the oil level again.
Model
GYEQ30AN
A
GYEQ20AN
023325-00EN01
Remarks
Cover the filter with waste
cloth to absorb dripping oil.
• Keep away from
surrounding protrusions
or edges.
• Improve ring protection
and sealability.
Maintenance / Service Data