Table of Contents
Advertisement
Cleaning Your Air Conditioner
Safety Clip
Wired Remote Controller
12
E-
To get the best possible use out of your air conditioner, you must clean
it regularly to remove the dust that accumulates on the air filter.
IMPORTANT
1
Open the front grille by pushing on both sides and center.
IMPORTANT
2
Remove the front grille.
2-1 Remove the safety clips.
2-2 Open the front grille about 45 and pull it forward.
3
Pull out the air filters.
4
Remove all dust on air filters with a vacuum cleaner or a brush. In case of
serious dust accumulation, put the air filter in warm detergent water and
shake it vertically.
N N
o o
t t
e e
N N
o o
t t
e e
5
Dry the air filter.
6
When you have finished, insert the air filters into the front grille.
7
Clean the unit with a vacuum cleaner or a brush once a month.
8
Reinstall the front grille and the safety clips.
N N
o o
t t
e e
N N
o o
t t
e e
N N
o o
t t
e e
After cleaning the air conditioner, press the Filter Reset button.
N N
o o
t t
e e
Wireless Remote Controller
Before cleaning your air conditioner, ensure that you have
switched off the electric circuit breaker used for the unit.
You must give attention when disassembling the front grille
and must check the safety clips have been installed.
If you do not check them, the front grille will drop suddenly
and you will be hurt.
When you have installed the Bio-Pure filter, do not allow any
liquids to contact the filter. It may lose its properties.
You can use all 2 points of the indoor unit for installing the front
grille and the safety clips depending on your requirement.
Advertisement
Table of Contents
