Start-Up Checklist - Carrier Aquazone 50PEC09-18 Installation, Start-Up And Service Instructions Manual

NOTE: To avoid injury to personnel and damage to equipment or
property when completing the procedures listed in this start-up
checklist, use good judgment, follow safe practices, and adhere to
the safety considerations/information as outlined in preceding sec-
tions of this Installation, Start-Up and Service document.
CUSTOMER: _____________________________
MODEL NO.: _____________________________
I. PRE-START-UP
DOES THE UNIT VOLTAGE CORRESPOND WITH THE SUPPLY VOLTAGE AVAILABLE? (Y/N)
HAVE THE POWER AND CONTROL WIRING CONNECTIONS BEEN MADE AND TERMINALS TIGHT?
(Y/N)
IS THE CONTROL TRANSFORMER SET TO THE CORRECT VOLTAGE? (Y/N)
HAVE WATER CONNECTIONS BEEN MADE AND IS FLUID AVAILABLE AT HEAT EXCHANGER?
(Y/N)
HAS PUMP BEEN TURNED ON AND ARE ISOLATION VALVES OPEN? (Y/N)
HAS CONDENSATE CONNECTION BEEN MADE AND IS A TRAP INSTALLED? (Y/N)
IS AN AIR FILTER INSTALLED AND CLEANED? (Y/N)
HAS THE FAN SPEED SELECTOR SWITCH BEEN SET TO THE DESIRED SETTING? (Y/N)
II. START-UP
IS FAN OPERATING WHEN COMPRESSOR OPERATES? (Y/N)
UNIT VOLTAGE — COOLING OPERATION
PHASE AB VOLTS
PHASE AB AMPS
CONTROL VOLTAGE
IS CONTROL VOLTAGE ABOVE 21.6 VOLTS? (Y/N)
IF NOT, CHECK FOR PROPER TRANSFORMER CONNECTION.
TEMPERATURES
FILL IN THE ANALYSIS CHART ATTACHED.
COAXIAL HEAT COOLING CYCLE:
EXCHANGER WATER IN
HEATING CYCLE:
WATER IN
AIR COIL COOLING CYCLE:
AIR IN
HEATING CYCLE:
AIR IN
Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.
Catalog No. 04-53500267-01
50PEC UNIT

START-UP CHECKLIST

JOB NAME: ____________________________________________
SERIAL NO.: ________________ DATE:
F WATER OUT
F WATER OUT
F AIR OUT
F AIR OUT
Printed in U.S.A. Form 50PEC-5SI Rev. A
.
F
F
F
F
Pg CL-1
________________
FT WG GPM
FT WG GPM
3-2020 Replaces: 50PEC-4SI