Table of Contents
Advertisement
Quick Links
INKA 356
INKA 356
INKA356 230V, INKA356 230V Syncro³, INKA356 24V, INKA356 24V Syncro³
INKA356 230V, INKA356 230V Syncro³, INKA356 24V, INKA356 24V Syncro³
INKA356 230V, INKA356 230V Syncro³, INKA356 24V, INKA356 24V Syncro³
INSTRUCTION MANUAL
INSTRUCTION MANUAL
CHAIN ACTUATOR
CHAIN ACTUATOR
EN
Force 350N – Strokes 300, 600, 800, 1000 mm
Strokes 300, 600, 800, 1000 mm
Electrical feeding 110-230V~ 50/60Hz and 24V
Electrical feeding
NEKOS S.r.l. - Via Capitoni, 7/5
Via Capitoni, 7/5 - 36064 Colceresa – VI –
+39 0424 411011
+39 0424 411011 – +39 0424 411013 - www.nekos.it - info@nekos.it
4420085 – Rev. 2010
CAUTION.
instructions to ensure personal safety.
The device is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lacking
experience and knowledge. Do not allow children to play with the
fixed controls and keep any remote-control units out of their reach.
Have installation checks performed periodically by qualified
personnel from a service centre authorised by the manufacturer.
Do not use if repair or adjustment is required.
CAUTION: if the power cable is damaged, it must be replaced by
qualified personnel from a service centre authorised by the
manufacturer.
CAUTION. Disconnect the power supply during cleaning or
maintenance operations. Do not use solvents or jets of water to
wash the appliance; the appliance should not be submerged in
water.
In the event of fault or malfunction, switch off the device at the
main switch. All repairs and adjustments (e.g. setting the stroke)
must only be performed by qualified personnel from a service
centre authorised by the manufacturer.
Always request exclusive use of original spare parts. Failure to
respect this condition could compromise safety and invalidate the
benefits contained in the warranty for the appliance. In the event of
any problems or queries, consult your agent or contact the
manufacturer directly.
The A-weighted sound pressure level is less than 70dB(A).
Carefully preserve these instructions after installation.
– ITALY
info@nekos.it
USER INSTRUCTIONS
Carefully
observe
all
the
2
following
installation
Advertisement
Table of Contents
Related Manuals for nekos INKA 356 Series
Summary of Contents for nekos INKA 356 Series
- Page 1 Carefully preserve these instructions after installation. NEKOS S.r.l. - Via Capitoni, 7/5 Via Capitoni, 7/5 - 36064 Colceresa – VI – – ITALY +39 0424 411011 +39 0424 411011 – +39 0424 411013 - www.nekos.it - info@nekos.it info@nekos.it 4420085 – Rev. 2010...
-
Page 2: Table Of Contents
MPROPER INSTALLATION CAN SERIOUSLY ENDANG CAN SERIOUSLY ENDANGER SAFETY nekos products have been manufactured in accordance with safety standards and conforms to products have been manufactured in accordance with safety standards and conforms to products have been manufactured in accordance with safety standards and conforms to... -
Page 3: Recognition
³ version the actuator has been equipped with the new system patented by SYNCRO NEKOS for coordinated synchronisation of a group of actuators (up to eight at the same time). Electronic control of speed is completely automatic device inside the actuator and... -
Page 4: Technical Data
CONSTRUCTION AND REGULATORY REFERENCES CONSTRUCTION AND REGULATORY REFERENCES The actuator of the INKA 356 series moves the window by means of a chain that runs INTENDED USE. The actuator is designed and built to move awning windows, The actuator is designed and built to move awning windows, The actuator is designed and built to move awning windows, inside the device. -
Page 5: Warning
(dimension A) (dimension B) LACK opens. A third wire G “3”, is both used or electronic synchronisation (Nekos REEN patent) and for the possible connection to K-LOCK electromechanical lock. INKA 356 24V Low tension actuators 24V can be powered using a specific RWA station with emergency battery or a security feeder with an output tension of 24V (min. -
Page 6: Calculation Of The Number Of Push / Retention Points
Screw holes for 110-230V~ actuators on bottom-hung windows (hinges at the bottom, support brackets to reset the quota. opening inwards from the top). For bottom hung window frames injury could be caused by accidental falls of the window. An appropriately sized flexible link arm or fall prevention safety system designed to resist a force equal to at least three times the total weight of the window MUST be installed. -
Page 7: Electrical Connections Electrical Connections
Drill the window frame at the marked points. C. Use brackets "A" art. 4010118 and hinge "C" art. 4010115 (both sold separately. Fig. 8). Use brackets "A" art. 4010118 and hinge "C" art. 4010115 (both sold separately. Fig. 8). Use brackets "A" art. 4010118 and hinge "C" art. 4010115 (both sold separately. Fig. 8). Fix the brackets (A) to the frame using flat head screws as indicated above. -
Page 8: Inka 356 Programming
If feeder cables require extending to the control button for low voltage actuators (24V 12. PROGRAMMING THE ACTUATOR cable sections should be selected accordingly. Conductor sections are indicated in the table on page 10 (Selection of cable section). 12.1. INKA 356 Programming IMPORTANT: in 24V actuators, wire Green “3”... -
Page 9: Reset Procedure - Valid For The Single
12.3. Overlap acquisition ACTUATOR DIP 1 DIP 2 FUNCTION RESET The operation that must be carried out to acquire the overlap (after the RESET procedure STROKE 600 INKA 356 – Max. has already been executed) is described below: Stroke 800 STROKE 700 ... -
Page 10: Checking For Correct Assembly Checking For Correct Assembly
Repeat the RESET procedure. The internal memory write process window frame, the NEKOS patent allows rapid unhooking of the chain. To perform this window frame, the NEKOS patent allows rapid unhooking of the chain. To perform this window frame, the NEKOS patent allows rapid unhooking of the chain. To perform this failed. -
Page 11: Rwa Certificate
Guarantee of good function of appliances agreed by the manufacturer implies that the 17. RWA CERTIFICATE latter undertakes to repair or replace free of charge and in the shortest period possible any parts that break while under warranty. The purchaser is not entitled to any reimbursement for eventual direct or indirect damage or other expenses incurred. - Page 12 Questa dichiarazione è fatta dal costruttore / This is declared by the manufacturer : NEKOS S.r.l. - Via Capitoni 7/5 - 36064 Colceresa – VI - Italy Rappresentato da / Represented by : Giuliano Galliazzo – A.D. Presidente / President CEO...