Selecting The Automatic Operating Mode - Samsung AQ12FAN User Manual

Selecting the Automatic Operating Mode

8
-
E
You can start the air conditioner in Auto mode from your remote
control. In the Auto mode, the cooling and heating operation is
selected automatically. You can also raise or lower the temperature
and the fan speed in the Auto mode.
1
If necessary, press the
Result: The operation indicator on the indoor unit lights up.
The air conditioner starts up in the mode selected
when the unit was last used.
The indoor unit beeps.
The air conditioner is fitted with a protection mechanism
IMPORTANT
to prevent the unit from being damaged when it is started
immediately after being:
Plugged in
Stopped
lt will start up normally after three minutes.
2
If the is not displayed at the top of the remote control,
press the button on the remote control one or more times until it
appears.
Result: The indoor unit beeps each time you press the
The air conditioner runs in the Auto mode.
The Auto mode cools and heats the room in optimum
condition by adjusting the indoor temperature
depending on the set temperature.
The mode may change from cooling into heating,
from heating into cooling depending on the current
temperature during operation.
Note
You can change modes at any time.
3
To adjust the temperature, press the
the required temperature is displayed.
Possible temperatures are between 16°C and 30°C inclusive.
Result:
Each time you press the
- The temperature is adjusted by 1°C
- The indoor unit beeps
button.
button one or more times until
button:
button.