Advertisement
(5) The following dialog box will be displayed. Click the Close Button after the process
ends.
(Messages will be displayed during the process, but just click the OK Button.)
(6) Open the front cover on the CPU Module and set the switch in the middle to RESET.
When the CPU Module indicators go out, return the switch to the original position.
You can now use communications.
6-10-4 E5@D Controller Setup
Set up programless communications. Perform the procedure that is given in 6-4-4 E5
Setup.
6-10-5 Checking Operation
The SP and RUN/STOP status of the E5 D Controllers will be changed to check operation. Make sure
that this will not create any problems in the controlled system.
E5@D Digital Temperature Controllers Communications Manual (H225)
6 Programless Communications
@
6
D Controller
6 - 81
Advertisement
