Problems Following Out - Husqvarna Automower Solar Hybrid Technical Manual

3. Place Automower in the charging station and
select Test OUT (3-2-5).
The mower will now leave the charging station
directly according to the stated direction. The
distance will be shown on the display, stated in
metres, as the mower runs.
4. Stop the mower after the required distance and
read the distance.
5. Reset the Proportion value when testing is
finished.
To test the settings in Exit angles:
1. State the value 100 % for Proportion first when
sector 1 is to be tested. State the value 0 % for
Proportion first when sector 2 is to be tested. All
areas below Follow loop out must be set to 0 % as
well.
2. Place Automower in the charging station and
select the Test OUT (3-2-5) function.
The mower will now leave the charging station
directly according to the settings under Exit
angles.
3. Reset the Proportion first value when testing is
finished.

3.5 Problems following OUT

IMPORTANT INFORMATION
If Automower does not find the right strength
on the loop signal when it leaves the
charging station, it will start to mow
immediately instead.
Tip! If Automower finds it difficult to follow the
guide wire out from the charging station, the
guide wire should, if possible, be routed further
out from the front edge of the charging plate.
Should this not be possible, reduce the reversing
length or set a lower Corridor width value.
If the mower has difficulty in finding or starting to
follow the boundary loop out from the charging
station, the Corridor width setting should be
increased. The Reversing distance setting may need
slight adjustment. The Reverse distance setting can
be found in the Exit anglesmenu.
3. INSTALLATION
3012-846
English - 51