Husqvarna Automower Solar Hybrid Technical Manual page 25

2. SPECIAL MENU FUNCTIONS
Press Arrow up to display further information in this
display mode. The Ar-signal is then shown instead, i.e.
the loop signal measured through the rear loop sensor.
The guideline values of approximately 70 – 320 also
apply for Ar. Press Arrow up to exit this display mode.
The sensors display mode presents:
• Collision:
To test the collision sensors: Hold the handle on
the underside of the Automower. Press on
different parts of the body. The display shows
None, Both, Left or Right. Continue to press on
the body until you see that both collision sensors
work.
• Lift:
To test the lift sensor, lift up the front part of the
body. When the body is lifted up, the lift sensor is
activated and YES is shown on the mower's
display. When the mower is in the lowered
position NO is shown.
• Tilt X and Tilt Y:
When Automower is horizontal the values should
be max ±3. Inclination up and to the left give a
negative values.
• Mower position:
States Mower normal pos. or: Mower reversed.
The battery display mode presents:
• Voltage:
A value of about 21 V signifies a fully charged
battery and about 18 V signifies a discharged
battery.
• Charging:
Shows how much of the charge remains in the
battery. When the battery is fully charged the
charge is about 4400 mAh (2200 mAh for
220 AC and Solar Hybrid). When the charge has
dropped to about 1200 mAh (700 mAh for 220
AC), the mower returns to the charging station. If
the ambient temperature is high, the available
capacity in the battery drops. The mower adapts
itself to this and then returns to the charging
station earlier.
• Current:
Shows the nominal regulated charging current to
and from the battery. A positive value indicates
that the battery is taking the charge while a
negative value indicates that the battery is not
taking the charge. On 230 ACX the current for
battery A and B is shown separately. On Solar
Hybrid current from both the solar panel and
from the battery is shown. If the mower finds
itself outside the charging station, a positive
battery current charges the battery from the solar
panel.
• Batt. Temp:
Shows the temperature of the battery. On
230 ACX the Batt. temp for battery A and B is
shown separately.
Collision:
Lift:
TiltX: 0
Mower normal pos.
Voltage:
Charging:
Current:
Batt. Temp:
220 AC
Voltage:
Charging:
Current bat A:
Batt. Temp A:
Current bat B:
Batt. Temp B:
230 ACX
Voltage:
Charging:
Solar current:
Current bat B:
Batt. Temp B:
Solar Hybrid
NONE
NO
TiltY: 0
19.7 V
2000 mAh
1750 mA
30ºC
19.7 V
3400 mAh
3670 mA
30ºC
3810 mA
29ºC
19.7 V
2000 mAh
515 mA
1750 mA
29ºC
English - 25