Using The Carpet Washer And Cleaning Modes - Hoover Power Scrub Elite User Manual

Hide thumbs Also See for Power Scrub Elite:
Table of Contents

Advertisement

Available languages

Available languages

CAUTION: Always unplug the carpet washer before performing any maintenance/troubleshooting
checks. Always empty and rinse out the clean and dirty water tanks and leave to air dry before
replacing. Do not leave solution stored in the tanks between uses.
IMPORTANT: Your dirty water tank is fitted with a float. When the dirty water tank is full, or the
floorhead is not in contact with the carpet, the float will shut off the suction on the carpet washer. You
will be able to hear if this has happened as the motor noise on the machine will increase. Once the
float is activated, empty the dirty water tank if full. If the dirty water tank is not full then turn off your
machine at the power switch and wait for the float to settle.

Using the carpet washer and cleaning modes

NOTE: Carpets should be dry vacuumed thoroughly before washing. For best overall results use in
deep clean mode. For heavily soiled areas it may be necessary to repeat the cleaning process. Make
crisscrossing strokes to the original pattern and overlap each pass.
Quick Clean Mode: Best for a quick, surface clean because carpets dry in about 45 minutes.
Deep Clean Mode: Best overall results for a thorough, deep clean.
Press the clean water/
solution tank release
button, pull and lift to
remove the tank.
Fill the clean water
tank with warm water
(max 40°C). Replace
the cap before refitting
the tank.
Twist the solution tank
cap anti-clockwise
to remove.
Tilt the clean water/
solution tank and line
up onto the carpet
washer. Push the tank
back until it clicks
into place.
OPERATION
Pour Hoover carpet
cleaning solution
into the tank. Replace
the cap.
Choose the cleaning
mode by turning the
dial on the base.
Quick Clean Mode:
Best for a quick,
surface clean with
carpets drying in
about 45 minutes.
Deep Clean Mode:
Best overall results for
a thorough, deep clean.
Twist the water tank
cap anti-clockwise
to remove.
Turn the wash/rinse
dial to 'wash'. The
SpinScrub brushes
deep clean your
carpets with water and
detergent removing
dirt and stains.
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cwgdh012

Table of Contents