Flying Wire Adapter; Flying Wire Adaptor (Top) With Wires - Xilinx Platform Cable USB II Manual

The connector is a 2-mm shrouded keyed header. See
X-Ref Target - Figure 10
Notes:
1. Ribbon Cable: 14-pin conductor, 1.0 mm center, round-conductor flat cable, 28 AWG (7 x 36) stranded conductors, gray PVC with pin 1 edge
marked.
2. 2-mm ribbon female polarized connector, IDC connection to ribbon. Contacts are beryllium copper plated 30 micro-inches gold plating over
50-micro-inches nickel. The connectors mate to 0.5-mm square posts on 2-mm centers.

Flying Wire Adapter

An adapter with wires (Figure
mm connector. The adapter makes it possible to use flying wires for connections to distributed terminals on a target system.
The adapter is a small circuit board with two connectors
with the 14-pin Platform Cable USB II male 2-mm connector. A 7-pin right-angle header on the top side of the adapter mates
with the standard Xilinx flying wire set.
Note:
This method of connection is not recommended because it can result in poor signal integrity. Additionally, damage can result if the
leads are unintentionally connected to high voltages.
The Xilinx product number for the flying wire set is HW-USB-FLYLEADS-G.
X-Ref Target - Figure 11
HI-SPEED
USB
CERTIFIED
DS593 (v1.2.1) March 17, 2011
Figure 10: High Performance Ribbon Cable
11) is provided for attachment to legacy target systems that do not incorporate a shrouded 2-
®
2mm
CONNECTOR
SIGNALS
Platform Cable USB II
JTAG or Serial or SPI
Model DLC10
HALT INIT WP PGND
---- ---- ---- Gnd
Power 5V 0.15A
TDI DIN MOSI Gnd
TDO DONE MISO Gnd
Serial XU - 12345
TCK CCLK SCK Gnd
TMS PROG SS Gnd
VREF VREF VREF ----
Made in U.S.A.
1.5 < VREF < 5.0 VDC
ADAPTER
Figure 11: Flying Wire Adaptor (Top) with Wires
Table 5, page 14 for vendor part numbers and pin assignments.
(Figure 12). The connector on the bottom side of the adapter mates
STATUS
JTAG / SERIAL / SPI
www.xilinx.com
Platform Cable USB II
DS593_10_112607
VREF / VREF / VREF
G ND / G ND / G ND
TCK / CCLK / SCK
HALT / INIT / WP
TDO / DO NE / M ISO
TDI / DIN / M O SI
TM S / PRO G / SS
DS593_11_021908
12