Safety Systems; Before Using For The First Time; Preparing The Appliance; Basic Operation - Bosch MUMS2 Series User Manual

en Before using for the first time
¡ During processing the swivel arm
disengaged or the release button
for the swivel arm was pressed.
Tip: You can easily adjust an incor-
rect parking position yourself.
→ "Troubleshooting", Page 39

Safety systems

You can find an overview of your ap-
pliance's safety systems here.
Start lock-out
Start lock-out prevents your appli-
ance from being switched on acci-
dentally.
The appliance can only be switched
on and operated if the swivel arm
has engaged correctly in position 1
or position 3.
Restart lock-out
Restart lock-out prevents your appli-
ance from automatically restarting
processing after a power failure.
The appliance is switched on again
after a power failure. Processing can-
not start again until the rotary switch
has been set to
Overload protection
The overload protection system pre-
vents the motor and other compon-
ents from being damaged through
being overloaded.

Before using for the first time

Before using for the
first time
Prepare the appliance for use.
Before using for the first time

Preparing the appliance

Press the release button and raise
1.
the swivel arm until it engages.
→ "Moving the swivel arm",
Page 34
34
⁠ .
Lift and remove the bowl.
2.
→ "Removing bowl", Page 35
Clean all parts that come into con-
3.
tact with food before using for the
first time.
→ "Cleaning and servicing",
Page 37
Put the cleaned and dried parts
4.
out ready for use.

Basic operation

Basic operation
You can find out everything you need
Basic operation
to know about operating your appli-
ance here.

Cable length

Adjust the length of the power cable
to your needs.
Adjusting cable length via cable
storage compartment
Pull the power cable out to the re-
1.
quired length.
To shorten the cable, push it into
2.
the cable storage compartment.

Moving the swivel arm

Press the release button and raise
1.
the swivel arm until it engages.
→ Fig.
3
a The swivel arm is fixed in posi-
tion 2.
Press the release button and move
2.
the swivel arm down until it en-
gages in the vertical position.
→ Fig.
4
a The swivel arm is fixed in posi-
tion 3.

Inserting bowl

Place the bowl in the base unit.
▶
→ Fig.
5