Changing The Boot Priority - Samsung NP-R518 User Manual (FreeDos) User Manual

Changing the Boot Priority

The default boot priority of your computer is the CD-ROM first, then a removable device
and then the hard disk drive in this order.
By default, the highest boot priority device is set to the CD-ROM/DVD drive. As an
example, the procedures to change the highest boot priority device to the hard disk drive
are described below.
1
Select the Boot menu in the BIOS
Setup.
2
Press <Enter> on the Boot Device
Priority item.
Boot Device Priority
NumLock
Enable Keypad
Summary screen
Boor-time Diagnostic Screen
PXE OPROM
Brightness Mode Control
Wireless Device Control
Smart Battery Calibration
Bonn_R518_Dos_Eng.indb 68
[Off]
Select system boot
[By NumLock]
options
[Disabled]
[Disabled]
[Only with F12]
[Auto]
[Always On]

3
Press the down key (↓) to move to the
AHCI HDD item and press the F6 key to
move up to the top item.
Boot Device Priority
[Boot priority order]
1. AHCI CD : XXXXXXXXXXXXXX
2. AHCI HDD : XXXXXXXXXXXXXXXX
3. USB KEY : N/A
4. USB CD : N/A
5. USB FDD : N/A
6. USB HDD : N/A
7. PCI BEV : N/A
8.
[Excluded from boot order]
- IDE HDD : N/A
- IDE CD : N/A
- PCI SCSI : N/A
- USB ZIP : N/A
- USB LS120 : N/A
4
Press the F10 key to save the settings
and exit Setup. The highest boot
priority device is now set to the Hard
Drive.
2009-03-25 오후 1:31:06