Setting Up Your Pc Software (Windows Only) - Samsung PPM42M6HS Owner's Instructions Manual

Setting up Your PC Software (Windows only)

The Windows display-settings for a typical computer are shown below. But the actual screens on your
PC will probably be different, depending upon your particular version of Windows and your particular
video card. But even if your actual screens look different, the same, basic set-up information will apply
in almost all cases. (If not, contact your computer manufacturer or Samsung Dealer.)
1
Right click the mouse on the Windows Desktop,
then click on Properties.
The Display Properties will be displayed.
2
Click on Settings tab, then set the Display Mode
with reference to the Display Modes Table.
You do not need to change the Colours settings.
3
Click on Advanced. A new settings dialog box
will be displayed.
4
Click on the Monitor tab, then set the Screen
refresh rate with reference to the Display Modes
2
Table. Set the Vertical Frequency and Horizontal
Frequency individually if you can do so instead of
setting the Screen refresh rate.
3
5
Click on OK to close the window, then Click on
OK button to the Display Properties window.
Automatic re-booting may commence at this
moment.
6
Shutdown the PC, and connect it to your PDP
Display. ("Connecting to the PC Input" on page
42)
➢
◆ The actual screens on your PC may look
different, depending on your particular
4
version of Windows and the type of your
PC.
◆ When you use your PDP Display as a PC
monitor, it supports Colours up to 32 bits.
◆ In this case, the display on the PDP Display
may look different depending on your
5
particular version of Windows or the PC
manufacturer.
◆ When connecting a PC (including the DVI
connection), you must set it to the display
settings that are supported by the PDP
Display. Otherwise, the message Out of
input range will be displayed.
English - 43