Page 1
M18 FCHS M18 FCHSC Original instructions...
Page 2
M18 FCHS M18 FCHSC Original instructions Alkuperäiset ohjeet Algupärane kasutusjuhend Originalbetriebsanleitung Πρωτότυπο οδηγιών χρήσης Оригинальное руководство Notice originale Orijinal işletme talimatı по эксплуатации Istruzioni originali Původním návodem k používání Оригинално ръководство за Manual original Pôvodný návod na použitie експлоатация Manual original Instrukcją...
Page 3
VIII Technical Data,Safety Instructions, Speci ed Conditions of Use, Declaration of Conformity, Batteries, Maintenance, Symbols Please read and save these instructions!
TECHNICAL DATA M18 FCHS M18 FCHSC Chain saw Production code 4678 37 02 ... 4743 51 02 ..000001-999999 ... 000001-999999 No-load chain speed 12,4 m/s 12,4 m/s Bar length max. 16“ (406,4 mm) 12“ (304,8 mm) Usable cutting length...
Page 21
Use extreme caution when cutting brush and saplings. The Additional Safety and Working Instructions slender material may catch the saw chain and be whipped toward It is recommended to cut logs on a saw-horse or cradle when opera- you or pull you o balance. ting the machine for the rst time.
Page 22
Remove the battery pack before starting any work on the appliance. WARNING! To reduce the risk of re, personal injury, and product damage due to a short circuit, never immerse your tool, battery pack or charger in uid or allow a uid to ow inside them. Corrosive or conductive uids, such as seawater, certain industrial chemicals, and bleach or bleach containing products, etc., Can cause a short circuit.
KNOW YOUR CHAIN SAW Chain Catcher A chain catcher prevents the saw chain from being thrown back Trigger Release Saw Chain towards the operator if the saw chain comes loose or breaks. Throttle Trigger Guide Bar Chain Drive Guide Bar Cover INSTRUCTIONS CONCERNING THE PROPER TECHNIQUES Bar Groove Front handle / Chain Brake...
Do not dispose of used battery packs in the household refuse or lower 2/3 to meet the rst cut. by burning them. Milwaukee Distributors o er to retrieve old When bucking on a slope always stand on the uphill side of the log.
RISK REDUCTION ASSEMBLY • It has been reported that vibrations from handheld tools may Assembling saw chain and guide bar contribute to a condition called Raynaud’s Syndrome in certain individuals. Symptoms may include tingling, numbness, and WARNING! If any parts are damaged or missing do not blanching of the ngers, usually apparent upon exposure to operate the machine until the parts are replaced.
Starting the chain saw a new one, available at your MILWAUKEE service agent. The part Before starting the chain saw, you should install the battery pack number is available in the product speci cation table in this in the chain saw and make sure the chain brake is in run position by manual.
Every 5 hours of operation EC DECLARATION OF CONFORMITY Replacement parts (Bar and chain) We declare under our sole responsibility that the product described Manufacturer MILWAUKEE OREGON under “Technical Data” ful lls all the relevant provisions of the Chain 4932464873...
Page 28
GB DECLARATION OF CONFORMITY SYMBOLS We declare as the manufacturer under our sole responsibility that the product described under „Technical Data“ ful lls all the relevant CAUTION! WARNING! DANGER! provisions of the following Regulations Remove the battery pack before starting any work on S.I.