Table of Contents
Advertisement
connections
J
Place the wireless receiver module at the rear of the listening
position. If the wireless receiver module is too close to the main unit,
some sound interruption may be heard due to interference.
If you use a device such as a microwave oven, wireless LAN Card
equipment, or any other device that uses the same frequency (5.8GHz)
near the system, some sound interruption may be heard due to
interference.
The transmission distance of a radio wave is about 10m, but may
vary depending on your operating environment. If a steel-concrete
wall or metallic wall is between the main unit and the wireless
receiver module, the system may not operate at all, because the
radio wave cannot penetrate metal.
This product(HT-XA100/XA100C) is compatible with the wireless receiver module SWA-3000.
M
Do not insert any other card except the TX card dedicated to the product. The product might be damaged or
the card may not be removed easily.
Do not insert the TX card upside down or in the reverse direction.
Insert the TX card when the DVD Player is turned off. Inserting the card when it is turned on may cause a
problem.
If the TX Card is inserted, sound is not output from the Rear Speaker connectors on the main unit.
The wireless receiving antenna is built into the wireless receiver module. Keep the unit away from water and
moisture.
For optimal listening performance, make sure that the area around the wireless receiver module location is
clear of any obstructions.
If no sound is heard from the wireless rear speakers, switch the mode to DVD 5.1 channel or Dolby ProLogic II.
In 2-CH mode, no sound will be heard from the wireless rear speakers.
20
CONNECTING THE VIDEO OUT TO YOUR TV
Choose one of the three methods for connecting to a TV.
METHOD3
(supplied)
METHOD 1 : HDMI
Connect the HDMI cable from the HDMI OUT jack on the back of the DVD Player to the HDMI IN jack
on your TV.
METHOD 2 : Component Video
If your television is equipped with Component Video inputs, connect a Component video cable(not
supplied) from the Component Video Output (P
Component Video Input jacks on your TV.
METHOD 3 : Composite Video
Connect the supplied Video cable from the VIDEO OUT jack on the back of the DVD Player to the
VIDEO IN jack on your TV.
M
This product operates in Interlace scan mode 576i(480i) for component output.
If you use an HDMI cable to connect a Samsung TV to the DVD Player, you can operate the Home Theater
using the TV's remote control. This is only available with SAMSUNG TVs that support Anynet+(HDMI-CEC).
Please check the n logo (If your TV has an n logo, then it supports the Anynet+ function.)
METHOD2
METHOD1
(supplied)
, P
and Y) jacks on the back of the DVD Player to the
R
B
21
Hide quick links:
Advertisement
Table of Contents
