Unpacking And Putting Away The Machine - Husqvarna Prisma 990 Operating Manual

Place the machine on the table, with the recess for the
handle furthest away from you, and fold down the
handle. Lift off the cover and put it aside. Remove the
foot control from the back of the machine.
Wipe the machine clean before you start sewing, and
be especially careful with the stitch plate and the space
around the needle. The machine is equipped with a
number of presser feet and these are packed in two
plastic bags. Regarding the placing of the accessories,
please refer to page 14 under "Accessory box".
Pull the plugs out of the wall outlet and the socket of
the machine. Wind the cords around your hand, starting
at the foot control and place them in the cord compart
ment of the foot control.
Make sure that all accessories are correctly placed in
the box. Slide the accessory box into place.
Lower the presser foot and hang the foot control on
the thread guide at the rear of the machine. The bottom
of the foot control should be turned toward the machine.
Fold down the handle and put on the cover.
4