Continuous Water Drainage; Maintenance - Toyotomi TD-C1410 Operating Manual

3. OPERATING INSTRUCTIONS
1. The Power indication light will turn on when the unit is plugged
in, regardless of whether the unit is operating or not.
2. Press button once to start operation. Press it again to stop
operation.
3. Press button as follows:
Press to set the desired fan speed. It can be adjusted between
high speed and low speed.
4. Press button to set the desired humidity level in the room, which
can be set from 40% to 80% at 5% intervals.
After a period of working, when environment humidity is lower
than the selected humidity by 2%, compressor will stop and fan
continues to run without dehumidification function; When envi-
ronment humidity is equel to or higher than the selected humidi-
ty by 2%, compressor will restart.
5. Press button and then
can only set the auto-shut off timer while the unit is operating
(on). You can only set the auto-start timer while the unit is in
standby (off). When the unit is on, press the
just or to setup the power-off time. When the unit is stand-
by, press the button and adjust
on time. Press button and then press the
set timer from 01-02......23-24 hour. Press
or button to adjust the time to 00 to cancel timer. The pro-
grammed time remains unchanged if the machine stops to work
due to water full or during defrosting.
6. Press button to activate CHILD LOCK. You can activate the
CHILD LOCK function by pressing the button for more than 5
seconds. The lamp will light up. When the CHILD LOCK function
is activated, all buttons are locked. To cancel, press the
ton for more than 5 seconds until the lamp turns off.
4. DRAINING THE COLLECTED WATER
When the drainage tank is full, the tank full indicator light will turn
on, the operation will stop automatically and the buzzer will beep
15 times to alert the user, that the water need to be emptied from
the drainage tank.
5. EMPTYING THE DRAINAGE TANK
1. Lightly press on the sides of the tank with both hands and pull
the tank out gently.
2. Discard the collected water.
or to set the timer setting: You
button and ad-
or to setup the power-
or button to
button and then
NOTE
1. Do not remove the float from the
water tank. The water full sensor
will no longer be able to detect the
water level correctly without the
float and water may leak from the
water tank.
2. If the drainage tank is dirty, wash it with cold or lukewarm water.
Do not use detergent, scouring pads, chemically treated dust
cloths, gasoline, benzene, thinner, or other solvents, as these
can scratch and damage the tank and cause water leakage.
3. When replacing the drainage tank, press the tank firmly into
place with both hands. If the tank is not positioned properly, the
"TANK FULL" sensor will be activated, and the dehumidifier will
not operate.
but-

6. CONTINUOUS WATER DRAINAGE

The unit features a continuous drainage port. Using a plastic pipe
(with an inner diameter of 10mm) inserts into drain hole (on inter-
mediate plate), reach out from side of water tank, install it in place,
and arrange the drain pipe.
The water in the drainage tank can be continuously drained out
from the continuous port on the unit.

7. MAINTENANCE

Cleaning the Dehumidifier
4
ENGLISH