Wireless Network - Samsung HT-D7200 User Manual

Wireless Network

You can connect to your network with a Wireless IP sharer. A wireless AP/IP router is required to make
a wireless network connection. To set the network confi guration options. see page 37.
Broadband
service
Wireless IP sharer
PC
✎
NOTE

To use a wireless network, your product must be connected to a wireless IP sharer. If the wireless IP
sharer supports DHCP, your product can use a DHCP (dynamic) or static IP address to connect to the
wireless network.

This product supports IEEE 802.11b,g and n. We recommend using IEEE 802.11n. When you play
video over a IEEE 802.11b or g connection, the video may not play smoothly.

Select a channel for the wireless IP sharer that is not currently being used. If the channel set for the
wireless IP sharer is currently being used by another device nearby, this will result in interference and
communication failure.

If you select the Pure High-throughput (Greenfi eld) 802.11n mode and set your AP's Security
Encryption type to WEP, TKIP or TKIPAES (WPS2Mixed), your Samsung home cinema will not support
the connection in compliance with new Wi-Fi certifi cation specifi cations.

If your AP supports WPS (Wi-Fi Protected Setup), you can connect to the network via PBC (Push
Button Confi guration) or PIN (Personal Identifi cation Number). WPS will automatically confi gure the
SSID and WPA key in either mode.

Connection Methods : You can setup the wireless network connection 3 ways:
- WPS(PBC)
- Auto Setup (Using the Auto Network Search function)
- Manual Setup

Wireless LAN, by its nature, may cause interference, depending on the operating conditions.
(AP performance, distance, obstacles, interference by other radio devices, etc).

Set the wireless IP sharer to Infrastructure mode. Ad-hoc mode is not supported.

When applying the security key for the AP (wireless IP sharer), only the following security protocols are
supported:
1) Authentication Mode : WEP, WPAPSK, WPA2PSK
2) Encryption Type : WEP, AES

To use the AllShare function, you must connect your PC to your network as shown in the fi gure.
The connection can be wired or wireless.
HT-D7200_ELS_1227.indd 27 HT-D7200_ELS_1227.indd 27
Networking with PC for
AllShare function
(See page 67)
27
English
2011-12-27 2011-12-27 3:28:06 3:28:06