Fujitsu ETERNUS DX Configuration Manual page 14

Chapter 3 Notes
3.10 Notes about Connections with a Windows Server
●
Measure to take after a problem occurs
Manually change the offline disks to online with the following procedure.
1
Click the [Start] button, select [Computer Management] under [Administrative Tools] and then select
[Manage Discs] (or [Disk Management]) in the left pane.
2
Select each offline disk, then right-click the selected disk to change the status to online.
If a firmware update of the ETERNUS DX is performed in a Hyper-V environment where a pass-through disk is
configured for the guest OS, the disk is recognized as a new disk and the pass-through disk is removed from
the physical hard disk. Therefore, the pass-through disk must be manually reconfigured to be restored.
The procedure for restoring (or reconfiguring) the disk is as follows:
1
Start "Hyper-V Manager".
2
Select the offline guest OS and click [Settings] in the right pane.
The settings pop-up for the guest OS appears.
3
In the settings pop-up under [SCSI Controller], select the hard drive that has the message "Physical
drive not found".
4
Select the appropriate disk for the [Physical hard disk] area in the right side of the window.
5
Click the [OK] button.
●
SAN Policy supported OSs
•
Windows Server
•
Windows Server
•
Windows Server
•
Windows Server
•
Windows Server
•
Windows Server
●
SAN Policy default value
OS
Windows Server
Windows Server
Windows Server
Windows Server
Windows Server
Windows Server
Windows Server
Windows Server
®
®
2019
®
2016
®
2012 R2
®
2012
®
2008 R2
®
2008
®
2019 (all editions)
®
2016 (all editions)
®
2012 R2 (all editions)
®
2012 (all editions)
®
2008 R2 Datacenter
®
2008 R2 Enterprise
®
2008 Datacenter
®
2008 Enterprise
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (SAS) for Windows
Copyright 2020 FUJITSU LIMITED
SAN Policy default value
Offline Shared
14
®
P3AM-3442-18ENZ0