Hyundai i20 Owner's Manual page 67

Safety system
To install the top-tether :
1. Route the Child Restraint System
top-tether over the Child Restraint
System seatback. Route the top-tether
under the headrest and between the
headrest posts, or route the top-tether
over the top of the vehicle seatback.
Make sure the strap is not twisted.
2. Connect the top-tether to the top-
tether anchorage, then tighten
the top-tether according to the
instructions of your Child Restraint
System's manufacturer to firmly
attach the Child Restraint System to
the seat.
3. Check that the Child Restraint System
is securely attached to the seat by
pushing and pulling the seat forward
and from side-to-side.
4-34
Installing a child restraint system by
lap/shoulder belt
OAI3039018 OAI3039018
To install a child restraint system on the
outboard or center rear seats, do the
following:
1. Place the child restraint system in
the seat and route the lap/shoulder
belt around or through the restraint,
following the restraint manufacturer's
instructions. Be sure the seat belt
webbing is not twisted.
2. Fasten the lap/shoulder belt latch
into the buckle. Listen for the distinct
"Click" sound.
Position the release button so that it is
easy to access in case of an emergency.
E2MS103005 E2MS103005
E2BLD310 E2BLD310