6-12.
SW-1589 Board
Preparation
1.
Remove the top panel assembly. (Refer to
2.
Remove the bottom plate assembly. (Refer to
3.
Remove the front assembly. (Refer to
Procedure
1.
Disconnect the harness from the connector on the SW-1589 board.
2.
Remove the two screws to detach the SW-1589 board assembly.
SW-1589 board assembly
Note
When installing the SW-1589 board assembly, fit the boss with the hole.
3.
Remove the button (PS) from the SW-1589 board.
SW-1589 board
Mark projection
Button (PS)
Note
When installing the button (PS), pay attention to the orientation.
4.
Install the removed parts by reversing the steps of removal.
PMW-1000
"6-3. Top Panel
Assembly")
"6-4. Bottom Plate
Assembly")
"6-11. Front
Assembly")
Hole
Connector
Boss
PSW2.6 x 6
Harness
6-15