Dometic DM2672 Operating Manual page 10

Refrigerator
Turning the ice maker on and off
6
➤ Ensure that the refrigerator is connected to 120
VAC.
➤ Open the valve supplying water to the refrigerator.
➤ Keep the bale arm in the up (OFF) position until
water enters the ice maker.
➤ Set the bale arm in the down (ON) position once
there is ice in the ice maker.
➤ Raise the bale arm to the up (OFF) position about
1-1/2 hours before traveling, to allow the water in
the mold assembly to freeze and prevent water
from splashing out of the mold assembly.
I
The ice maker will automatically fill the mold
assembly and eject the ice cubes into the
storage bin until it is full.
4.6 Turning off the refrigerator
Do not allow the refrigerator to run unattended when there is a risk of loss of electricity or fuel.
Food spoilage could occur.
➤ Press the ON/OFF button on the control panel to the OFF position to shut off all power to the refrigerator.
I
The refrigerator's control system will consume a few milliamps even after it is turned off. If the RV is being
put into winter storage, put the RV batteries on a battery charger or turn off the RV's main 12 VDC switch to
prevent the battery from discharging.
I
Refer to section "3.1 Understanding the control panel" on page 5.
EN
Adjusting the ice cube size
7
Adjusting
Ice Level
Screw
Bale Arm
Cover
I
Read before proceeding:
• The water supply system must have a minimum
pressure of 15 pounds-per-square-inch gauge
(psig).
• A 1/4" diameter water line to the water valve must
be used at the rear of the refrigerator.
• The water line must have a manual shutoff valve in
an easily accessible location.
• The maximum water level is represented by a thin
line on the mold assembly. Do not allow the water
level to exceed this line.
➤ Remove the protective cover from the ice maker by
inserting a flat-bladed screwdriver into the slot and
gently twisting the screwdriver.
➤ Adjust the ice cube size by turning the adjusting
screw counterclockwise to increase the size of the
ice cubes, and clockwise to decrease the size of
the ice cubes.
I
Do not turn the adjustment screw more than
one revolution at a time.
➤ Place the protective cover back on the ice maker.
➤ Allow the ice maker to cycle several times before
making further adjustments.
10