Fisher & Paykel ActiveSmart E372B Installation Instructions Manual page 9

Hide thumbs Also See for ActiveSmart E372B:

8. Connect one locking key to each side of the water

filter cartridge in between the cartridge and the

locking collet as shown in Diagram 4.

9. To flush the water filter of any trapped air,

harmless carbon fines and to also check for leaks,

aim the end of the tubing into a bucket, turn

isolating faucet on and run at least 4L of water

through. Once complete, turn isolating faucet off.

10. Locate desired position for water filter noting

carefully the following points:

• It is recommended to fit the water filter in a

vertical orientation with the water filter head at

the top. This will minimise water leakage when

replacing cartridge.

• Ensure the filter is in a convenient location to

access every 6 months for replacement. We

suggest that this location is beside the water

filter supply faucet in a cupboard beside the

refrigerator.

• A minimum clearance of 64mm from the bottom

of the filter cartridge is required to perform

cartridge removal.

• Do not screw water filter to refrigerator.

11. Attach double sided foam to the back of the water filter head as shown in Diagram 5.

Write the date to be replaced on the filter (date installed + 6 months). Remove the double

sided foam backing and attach the filter to the desired position, reinforcing the filter with

the screws provided as located in step 10 (refer to the previous page).

https://producthelp.fisherpaykel.com/au/Cool/Fridges/Bottom_Freezer/Without_Ice_and_Water/790mm/RF522BRPX6/User_G...

Diagram 4 Locking key

Updated: Mon, 27 Apr 2020 00:46:14 GMT

Diagram 5

Double sided

Table of Contents