Fisher & Paykel ActiveSmart E372B Installation Instructions Manual page 11

System tested and certified by NSF International against NSF/ANSI Standard 53 for the reduction of Asbestos, Atrazine,
Benzene, Cyst, Carbofuran, Lead, Lindane, Mercury, P-Dichlorobenzene, Toxaphene & Turbidity; against Standard
NSF/ANSI 42 for the reduction of Chlorine Taste and Odour and Nominal Particulate Class I to a capacity of 2,838L
(750gal).
Before you start using the Ice & Water or Automatic Ice function
• Check your refrigerator is switched on.
• Check that the isolation tap has been connected and turned on.
• Allow at least 2 hours for your refrigerator to cool before use.
For Ice & Water models only:
• Run through and discard the first 3L of water from your water dispenser, stopping intermittently to remove
trapped air in the system. Failure to do this will result in excessive dripping from your dispenser.
https://producthelp.fisherpaykel.com/au/Cool/Fridges/Bottom_Freezer/Without_Ice_and_Water/790mm/RF522BRPX6/User_G...
• All connections must be checked for
leaks.
• Ensure 6mm (1/4") tubing is routed
away from sharp objects, sharp corners
(beware of kinking the tube as this will
stop water flow), clear of the
refrigerator rear compartment and not
in a location where it can be kinked or
squashed.
• Ensure all push-fit connections are
firmly pushed into place. The tube
should push in 16mm before reaching
the stop.
• If tubing is removed at any point, re-cut
the end and re-insert. Tubing must be
fully inserted to avoid leaks.
• To remove tube from connection points
first turn off the isolating faucet. Gently
push the dispensing pad a few times
using a glass or container to remove
the static line pressure. Push in the
collet firmly while pulling back on the
tubing at the same time, as shown in
Diagram 10.
Diagram 10
Updated: Mon, 27 Apr 2020 00:46:14 GMT
Powered by
11