Working With The Simatic Usb-Prommer - Siemens SIMATIC USB-Prommer Comissioning Manual

Working with the SIMATIC USB-Prommer

Requirement: The SIMATIC USB-Prommer is connected to your PC as described above.
1. Insert the desired storage medium:
– Micro Memory Cards into the Micro Memory Card interface
– SIMATIC S5/S7 Memory Cards into the MEM-CARD interface
– S5 EPROM/EEPROM modules using the SIMATIC S5 programming adapter into the
2. Connect the supplied plug-in power supply when you are using S5/S7 Memory Cards or
S5 EPROM modules.
3. Start in the SIMATIC STEP 7 software or the SIMATIC STEP 5 software.
4. Make sure that the programming interface of your SIMATIC software is set to "External
prommer" at the "USB" port with the "Memory Card Parameter Assignment" panel.
5. Edit your storage medium.
6. Remove the storage medium when you are done with editing.
NOTICE
Programming
The BUSY LED lights up during programming.
Do not unplug the memory module, the USB cable or the plug-in power supply during
programming.
Simultaneous operation
Simultaneous operation of SIMATIC S5 modules, SIMATIC Memory Cards and SIMATIC
Micro Memory Cards is not possible. When SIMATIC Micro Memory Cards and SIMATIC
S5 or S7 Memory Cards are plugged in, the SIMATIC S5/S7 Memory Cards are preferred.
10
MEM-CARD interface
WARNING
Commissioning Manual, 04/2020, A5E50041544-AA
5
USB-Prommer