Main Board-2 - Sony HT-X9000F Service Manual

HT-X9000F/XF9000

2-16. MAIN BOARD-2

Note 1: When the MAIN board is replaced, be sure to refer to "SE-
RIAL NUMBER WRITING WORK WHEN THE MAIN
BOARD REPLACED" on page 5.
hole
1 screw
(B3
left side
3 Move the SK1-JACK board
cable to the outer side.
2 Move the FFC (28P)
to the outer side.
4 Move the SK1 IR REP board
Turn over.
Note 3: When the MAIN board block is removed from
the main chassis block, the shield (pana) and
radio wave absorption sheet will detach from
the MAIN board.
When assembling, remove the shield (pana)
and radio wave absorption sheet from the main
chassis block, and install them onto the MAIN
board.
7 shield (pana)
8 radio wave absorption
sheet
9 gasket (SL)
9 gasket (SL)
left side
22
B
6 MAIN board block
1 screw
5
(B3 5)
groove
5)
B
rib
rib
cable to the outer side.
Note 4: When installing the shield (pana),
align the rib and hole.
rib
front side
hole
0 MAIN board
Note 2: When installing the MAIN board block,
align the hole and groove with the two ribs.
top side
main chassis block
front side
OK
Touching.
NG
Missing.
MAIN board
left side
two on-board clips
right side
NG
No touching.
two on-board clips
shield (pana)
two on-board
clips
two on-board clips two on-board clips