ZyXEL Communications Parental Control Gateway HS100/HS100W User Manual page 56

LINK TAB
PARENTAL General
CONTROL
Bypass List
FIREWALL Settings
Filter
Services
REMOTE MGMT TELNET
FTP
WWW
SNMP
DNS
Security
UPnP UPnP
LOGS View Log
Log Settings
MAINTENANCE Status
DHCP Table
Any IP
F/W Upload
Configuration
Restart
LOGOUT
Introducing the Web Configurator
Table 2-17 Screens Summary
Use this screen to enable/disable parental control, configure idle
timeout and group categories, register for content filtering service
and edit user profiles.
Use this screen to allow devices in your network access the Internet
without using parental control.
Use this screen to activate/deactivate the firewall and log packets
related to firewall rules.
This screen allows you to block sites containing certain keywords in
the URL and set the days and times for the HomeSafe to perform
content filtering.
Use this screen to enable service blocking.
Use this screen to configure through which interface(s) and from
which IP address(es) users can use Telnet to manage the
HomeSafe.
Use this screen to configure through which interface(s) and from
which IP address(es) users can use FTP to access the HomeSafe.
Use this screen to configure through which interface(s) and from
which IP address(es) users can use HTTP to manage the
HomeSafe.
Use this screen to configure your HomeSafe's settings for Simple
Network Management Protocol management.
Use this screen to configure through which interface(s) and from
which IP address(es) users can send DNS queries to the HomeSafe.
Use this screen to change your anti-probing settings.
Use this screen to enable UPnP on the HomeSafe.
Use this screen to view the logs for the categories that you selected.
Use this screen to change your HomeSafe's log settings.
This screen contains administrative and system-related information.
This screen displays DHCP (Dynamic Host Configuration Protocol)
related information and is READ-ONLY.
Use this screen to allow a computer to access the Internet without
changing the network settings of the computer, when the IP
addresses of the computer and the HomeSafe are not in the same
subnet.
Use this screen to upload firmware to your HomeSafe.
Use this screen to backup and restore the configuration or reset the
factory defaults to your HomeSafe.
This screen allows you to reboot the HomeSafe without turning the
power off.
Click this label to exit the web configurator.
HomeSafe User's Guide
FUNCTION
2-23