Bailouts - Suunto EON CORE 2.0 User Manual

Suunto EON Core
2. Scroll to Setpoint with the upper button and select with the middle button.
3. Scroll to Switch low or Switch high and select with the middle button.
4. Adjust the depth value for the setpoint switch with the lower or upper button and accept
with the middle button.
5. Keep middle button pressed to exit menu.
Popup notifications indicate when the setpoint is switched.
During a rebreather dive, you can also switch to a custom setpoint at any time.
To change to a custom setpoint:
1. While diving in a rebreather mode, keep middle button pressed to enter main menu.
2. Scroll to Custom setpoint and select with the middle button.
3. Adjust the setpoint value as needed with the lower or upper button and accept with the
middle button.
A popup notification confirms the custom setpoint switch.
NOTE: When you change to a custom setpoint, the automatic setpoint switching is
turned off for the remainder of the dive.

3.27.4. Bailouts

If at any point during a rebreather dive you suspect a malfunction of any sort, you should
switch to a bailout gas and abort the dive.
To change to a bailout gas:
1. Keep the middle button pressed to enter main menu.
2. Scroll to OC gases and select with middle button.
3. Scroll to the desired bailout gas and select with the middle button.
After a bailout gas is selected, the setpoint field is replaced with the pO
open-circuit gas.
If the malfunction is rectified or the dive situation otherwise normalizes, you can switch back
to a diluent using the same procedure as below, but selecting from CC gases.
36
value of the selected
2