System Management Terminal Interface Summary; Table 72 Smt Main Menu; Table 73 Main Menu Summary - ZyXEL Communications ADSL 2+ Gateway P-660HW-T1 User Manual

P-660H/HW/W-T Series User' Guide
Table 71 Navigating the SMT Interface
OPERATION
Entering
information
Required fields
N/A fields
Save your
configuration
Exit the SMT
After you enter the password, the SMT displays the main menu, as shown next.

Table 72 SMT Main Menu

Getting Started
1. General Setup
2. WAN Backup Setup
3. LAN Setup
4. Internet Access Setup
Advanced Applications
11. Remote Node Setup
12. Static Routing Setup
14. Dial-in User Setup
15. NAT Setup

18.2.1 System Management Terminal Interface Summary

Table 73 Main Menu Summary

# MENU TITLE
1 General Setup
2 WAN Backup Setup
211
KEY STROKE DESCRIPTION
Type in or press You need to fill in two types of fields. The first requires you to
[SPACE BAR], type in the appropriate information. The second allows you to
then press cycle through the available choices by pressing [SPACE BAR].
[ENTER].
?
< > or All fields with the symbol <?> must be filled in order to be able
ChangeMe to save the new configuration.
All fields with ChangeMe must not be left blank in order to be
able to save the new configuration.
<N/A> Some of the fields in the SMT will show a <N/A>. This symbol
refers to an option that is Not Applicable.
[ENTER] Save your configuration by pressing [ENTER] at the message
"Press ENTER to confirm or ESC to cancel". Saving the data on
the screen will take you, in most cases to the previous menu.
Type 99, then press [ENTER].Type 99 at the main menu prompt
and press [ENTER] to exit the SMT interface.
Copyright (c) 1994 - 2004 ZyXEL Communications Corp.
Prestige 660W-T1
Enter Menu Selection Number:
DESCRIPTION
Use this menu to set up your general information.
Use this menu to setup traffic redirect and dial-back up.
Main Menu
Advanced Management
21. Filter and Firewall Setup
22. SNMP Configuration
23. System Security
24. System Maintenance
25. IP Routing Policy Setup
26. Schedule Setup
99. Exit
Chapter 18 Introducing the SMT