Setting Up Your Computer's Ip Address - ZyXEL Communications ZyXEL ZyWALL IDP 10 Quick Start Manual

By default remote management is disabled on both the LAN and WAN ports.
You must first enable remote management on these ports via the console port
or the MGMT port if you want to configure the ZyWALL IDP using these ports.

6 Setting Up Your Computer's IP Address

Use this section to set up your computer to use a static IP address of 192.168.1.1, 192.168.1.2 or from
192.168.1.4 to 192.168.1.254 with a subnet mask of 255.255.255.0. This is necessary to ensure that
your computer can communicate with your ZyWALL IDP.
Your computer must have an Ethernet card and TCP/IP installed. TCP/IP should already be installed on
computers using Windows NT/2000/XP, Macintosh OS 7 and later operating systems.
Windows 2000/NT/XP
1. In Windows XP, click Start, Control Panel. In Windows 2000/NT, click Start, Settings, Control
Panel.
In Windows XP, click Network Connections.
2.
In Windows 2000/NT, click Network and Dial-up Connections.
Right-click Local Area Connection and then click Properties.
3.
4. Select Internet Protocol (TCP/IP) (under the General tab in Windows XP) and click Properties.
ZyWALL IDP 10 Quick Start Guide
11