Measuring Temperature (35Xp-A Only) (See Figure 9); Measuring Frequency (35Xp-A Only) (See Figure 10); Measuring Ncv (Non-Contact Voltage) (See Figure 11) - Amprobe 5XP-A User Manual

Find Quality Products Online at:
Measuring Temperature
(35XP-A only) (See Figure 9)
1. Set the function switch to appropriate °C or °F range.
2. Connect the K-type thermocouple to a TEMP adapter
(XR-TA). Match the polarity of the adapter to the
polarity of the thermocouple.
3. Connect the TEMP adapter to the V  and COM
inputs.
Note: The 35XP-A is compatible with all K-type
thermocouples. The K-type bead thermocouple
supplied with the meter is not intended for contact
with liquids or electrical circuits.
4. Expose the thermocouple to the temperature to be
measured.
5. Read the display.
Measuring Frequency
(35XP-A only) (See Figure 10)
1. Set the Function Switch to Hz.
2. Connect the test leads: Red to Hz, Black to COM.
3. Connect the test probes to the signal source.
4. Read the display.
Measuring NCV
(Non-Contact Voltage) (See Figure 11)
1. Range switch may be set to OFF or any function/range.
2. Test leads are not used for the NCV test.
3. Press the NCV button. The display goes blank, a tone
sounds and the red LED next to the NCV button on the
front panel lights up to verify that the instrument is
operational. While pressing the button, hold the top-
center of the meter (sensor location) close to the
conductor/circuit in question.
4. If a voltage in the range of 70 to 600 V ac is present, a
tone sounds and the red LED next to the NCV button
on the front panel lights up.
8
GlobalTestSupply
www. .com
sales@GlobalTestSupply.com