Product Diagram; Assembling Puresteam Xl - PURE PureSteam XL Operation Manual

PRODUCT DIAGRAM

1: Steam Nozzle
2: Steam Handle
3: Hanger/Nozzle Holder
4: Steam Hose
5: Telescopic Pole
6: Pole Insert Base
7: Water Fill Tank
8: Power Switch
9: Wheel
10: Power Cord
11: Unit Base
12: On/Off Light
13: Steam Hose Base
PureSteam XL also
includes two attachments: a
Garment Hanger and Fabric
Brush (not shown).
4 3

ASSEMBLING PURESTEAM XL

1: Remove all contents in the box to ensure you
have all the pieces listed on Page 3.
2: Fully extend the Telescopic Pole, To do so, first
open the clips and loosen the poles. Then, fully
extend the poles and close the clips to lock in
place (see Figure 2). Make sure the pole is locked
into place and cannot be pushed down.
NOTE: To ensure a steady flow of steam it is best
to fully extend the steam hose and telescopic pole
when operating PureSteam XL.
3: To attach the hanger/nozzle holder, align the
tabs in the holder with the grooves on the pole
and push down (see Figure 3).
4: Insert the bottom of the telescopic pole into the
pole insert base (see Figure 4) so that the nozzle
holder faces the rear of the steamer. Pointing
the nozzle holder towards the rear will ensure
the stability of the steamer when garments are
hanging from the hanger holder.
5: To attach the steam hose: Align the screw at the
bottom of the steam hose with the unit base, and
then turn the screw clockwise to tighten the hose
with unit (see Figure 5). Then, place the steam
nozzle on the nozzle holder.
CAUTION: To prevent steam from causing bodily
injury or damage to surfaces, always hang the
steam nozzle on the nozzle holder when not in
use. Do not lay the steam hose on the floor as
condensation may occur and cause unwanted
water droplets in the steam.
CAUTION: Pulling on the steam hose with
excessive force will damage it and may cause a
steam leak.
4 5