Zanussi ZWF 14791 W User Manual page 18

Operating sequence
IMPORTANT!
If an option is chosen that is not allowed with
the selected programme, the red pilot light of
the Start/Pause button will flash 3 times.
9. Display
The display shows the following information:
Duration of the selected programme
After selecting a programme, the duration is
displayed in hours and minutes (for example
2.05). The duration is calculated automatically
on the basis of the maximum recommended
load for each type of fabric.
After the programme has started, the time
remaining is updated every minute.
ATTENTION!
When selecting the «proportional»
programmes, the diplay shows the washing
duration of the maximum recommended load.
After the «Start/Pause» button has been
pressed, on the display appears an arrows
animation indicating that the appliance is
calculating the laundry amount and the real
duration. During this time, the washing duration
shown decreases.
18
When the calculating phase has finished, the
arrows animation desappears from the display
and the washing time is adjusted to the real
load.
Washing programme phase icons
By selecting the wash programme, the washing
programme phase icons corresponding to the
various phases making up the programme are
shown in the upper part of the display.
After you have pressed the Start/Pause button
and the machine has started, the «Door
Locked» icon is lighted-on and only the
phase running icon stays on. When the
programme has finished, a flashing zero
« » is displayed and the «Door Locked»
0.00
icon desappears.
Delayed start
The selected delay (20 hours max) set by
means of the relevant button appears on the
display for about 3 seconds, then the duration
of the previously selected programme is
displayed. The relevant phase icon
lighted-on.
is