Table of Contents
Advertisement
Appliance Mounting Information
WARNING:
The following conditions are required for proper installation of the SMA
appliance:
1. The SonicWall appliance is designed to be mounted in a standard 19-inch (48.26 cm) rack
mount cabinet.
2. Use the mounting hardware recommended by the rack manufacturer and ensure that the
rack is adequate for the application.
3.
Ensure that no water or excessive moisture can enter the unit.
4. Allow unrestricted airflow around the unit and through the vents on the side of the unit. A
minimum of 1 inch (25.44mm) clearance is recommended.
5. Route cables away from power lines, fluorescent lighting fixtures, and sources of noise such
as radios, transmitters, and broadband amplifiers.
6. Mount in a location away from direct sunlight and sources of heat. A maximum ambient
temperature of 104º F (40º C) is recommended.
7. If installed in a closed or multi-rack assembly, the operating ambient temperature of the rack
environment may be greater than the room ambient. Therefore, consideration should be
given to installing the equipment in an environment compatible with the maximum
recommended ambient temperature.
8. Mount the SonicWall appliances evenly in the rack in order to prevent a hazardous condition
caused by uneven mechanical loading.
9. Four mounting screws, compatible with the rack design, must be used and hand-tightened to
ensure secure installation. Choose a mounting location where all four mounting holes line up
with those of the mounting bars of the 19-inch rack mount cabinet.
10. A suitably rated and approved branch circuit breaker shall be provided as part of the building
installation. Follow local code when purchasing materials or components.
11. Consideration must be given to the connection of the equipment to the supply circuit.
Appropriate consideration of equipment nameplate ratings must be used when addressing
this concern. Do not overload the circuit.
12. Reliable grounding of rack-mounted equipment must be maintained. Particular attention
must be given to power supply connections other than direct connections to the branch
circuits, such as power strips.
13. The included power cord(s) are approved for use only in specific countries or regions. Before
using a power cord, verify that it is rated and approved for use in your location.
14. Minimum power cord rating for European Union (CE): Certified power supply cord not lighter
than light PVC sheathed flexible cord according to IEC 60227, designation, or H05 VV-F or
H05 VVH2-F2, and rated for at least 3G 0.75 mm².
15. The following statement applies only to rack-installed products that are GS-Marked: This
equipment is not intended for use in workplaces with visual display units, in accordance with
§2 of the German ordinance for workplaces with visual display units.
16. This product is not intended to be installed and used in a home or public area accessible to
the general population. When installed in schools, this equipment must be installed in a
secure location accessible only by trained personnel.
SonicWall SMA 6210-7210
Safety and Regulatory Reference Guide
2
Advertisement
Table of Contents
