Section 2 Common Operations; Turning On/Off The Radar Image Distribution Function - JRC JMR-5400 Series Instruction Manual

Section 2 Common Operations

2.1 Turning ON/OFF the Radar Image Distribution Function

Memo
• Network setting must be performed before enabling the radar image distribution function. The
installer is requested to perform the setting by referencing "Section 5 Installation Setting and
Checking" of this manual.
• This setting is required for both the display units on the master side that distribute images and
the display units on the slave side that receive images.
The following three types of functions of this equipment cannot be used concurrently.
• Radar image distribution function *Function described in this manual
• Small target highlight
• 2nd PPI display (26-inch monitor version only)
The radar image distribution function must be set to ON to use the radar image distribution function.
1
Select the "Menu" button at the top right corner of the screen.
2
Select "Settings".
3
Select "Network Video".
4
Set the "Network Video" checkbox to ON.
Memo
When "Small Target Highlight" is ON, the "Network Video" checkbox cannot be set to ON. "Small
target highlight" must be set to OFF according to the instructions on the popup menu.
When the "Network Video" checkbox is ON, "Small Target Highlight" and "2nd PPI" cannot be set to
ON. To use any of these functions, the "Network Video" checkbox must be set to OFF.
Network Video
Simple ISW(LAN)
Combining
Network Video
Network Video
The available functions will switch.
Network Video On
- Simple ISW(LAN)
- Combining
Network Video Off
- Small Target Highlight
- 2nd PPI(26inch Monitor Only)
2-1 Section 2 Common Operations
3