Table of Contents
Advertisement
Alarms
TINYVIEW has two programmable alarms. Both
use the LCD display to show an alarm state.
Both are fully programmable for:
i.
Alarm trip point
ii. Over or under value.
iii. Latching or non-latching.
Alarm status is shown by the presence of Lo1,
Lo2, Hi1 and Hi2 indicators at the top of the
LCD. These can be cleared via the Windows
software without interrupting the logging.
Display
Numerical reading: Actual temperature or
Relative Humidity level. For temperature, an
arrow pointing to the bottom of the display
indicates the units used (degrees Centigrade or
Fahrenheit). The display is updated every 4
seconds.
Word 'STOP':
Display blank:
turns the display off after 5 minutes to
preserve battery life. When you connect to the
logger in GLM the display turns on again.
Logger in stop mode.
In stop mode the logger
3
Advertisement
Table of Contents
