Before First Use; Daily Use - Zanussi FCS 1020 C User Manual

(A)
(B)
(C)
(D)
(E)

Before first use

Warning!
Ensure that the electrical and water connections comply
with the installation instructions.
Important! Remove any material from the drum.
Important! We recommend you to run a wash programme
without any load, to clear any residues which may have

Daily use

Load the laundry
Open the door by carefully pulling the door handle out-
wards. Place the laundry in the drum, one item at a time,
shaking them out as much as possible. Close the door.
The light A illuminates when the machine is performing
the washing phase .
The light B illuminates when the machine is rinsing .
The light C illuminates when the machine is spinning .
The light D illuminates at the end of the washing cycle.
The light E indicates if the door can be opened:
• The light is lit: the door cannot be opened.
• The light is out: the door can be opened.
• The light is flashing: the door can soon be opened.
been left by the manufacturing process. Pour approx. 100
ml of detergent straight into the drum and run a cotton
cycle at 60°C. When the programme is finished the
machine will be ready to use.
Measure out the detergent and the fabric softener
Pull out the dispenser
drawer until it stops.
Measure out the amount of
detergent required, pour it
into the larger compart-
ment on the left .
Select the required programme by means of the
programme selector dial (9)
Turn the programme selector dial to the required pro-
gramme. The selector can be turned either clockwise or
anticlockwise.
The green light of button 6 starts to flash
If required, pour fabric
softener into the smaller
compartment marked
(the amount used must not
exceed the «MAX» mark
in the drawer). Close the
drawer gently.
7